Installation/setup fabricator 211i – Tweco 211i Fabricator User Manual

Page 57

Advertising
background image

INSTALLATION/SETUP

FABRICATOR 211i

Manual 0-5157

3-25 INSTALLATION/SETUP

3.21 Setup For SPOOL GUN MIG (GMAW) Welding With Gas Shielded MIG Wire

Select MIG mode with the Process Selection Control.
For setup and operation of the spool gun, please refer to the spool gun operations manual.
Switch the MIG GUN/SPOOL GUN switch inside the wire feed compartment to SPOOL GUN.
Connect the shielding gas for the to the Shielding Gas Inlet on the rear panel of the Power Source.

1. Make sure the welding

power source is turned

OFF before connecting

the welding gun.

2. Open side panel and

loosen thumb screw.

3. Insert the back end of the

Spool gun into the gun

receiving bushing.

4. Tighten thumb screw and

replace side panel.

5. Connect gas supply fi tting

and tighten with a wrench.

6. Align Control Plug to

panel fi tting and tighten

securely.

!

WARNING

Before connecting the work clamp to the work make sure the main power supply is switched OFF.
Secure the welding grade shielding gas cylinder in an upright position by chaining it to a suitable stationary

support to prevent falling or tipping.

Thumb screw

Art #

A-11629

Advertising
This manual is related to the following products: