Tweco 9-9515 User Manual
Page 11
Advertising
December 7, 2006
11
Manual 0-4952 Rev. AA.01
5. In GCM-2000 applications, the harness connector for harness receiver J6 must be aligned as shown.
Harness Receiver J6
Align connector edges
on this side.
Art # A-07349
6. Position the side panel and PCB assembly against the module. Fasten the assembly in place with hardware
removed previously.
7. Attach the two new Transducer harnesses to the PCB. The one from the manifold will go to JP4 and the one from
the H-35 input will go to JP3. See illstration below.
Transducer harness from the manifold (left) to JP4
Transducer harness from the “Right side” H-35 input connection to JP3
Art # A-07622
Illustration is for showing new Transducer connections only. Other connections may not apply.
Advertising