Tweco 9-9515 - Manual (Page 4)

December 7, 2006 4 Manual 0-4952 Rev. AA.01
7. Disconnect the hardware fastening the side panel to the control module. Carefully pull the panel away from the
module. Any remaining harnesses connected to the PCB on the inside of the panel will restrict motion. Do not
cause any tension on these wire harnesses.
Hardware Locations
Art # A-07025
8. Carefully disconnect any remaining wire harnesses connected to the PCB. The J8 connector for the ribbon cable
includes levers at each end. Move these levers away from the ribbon cable to release the cable from the connec-
tor.
9. When all harnesses are disconnected, let the side panel and PCB assembly lie on a flat surface.