Viking Pump TSM270.1: RL 16 and 25 Standard - Manual (Page 10)

SECTION TSM 270.1 ISSUE A PAGE 10 OF 12
TECHNICAL SERVICE MANUAL
VIKING PUMP, INC. • A Unit of IDEX Corporation •
Cedar Falls, IA 50613 USA

2004 Viking Pump Inc.
All rights reserved
WARRANTY
Viking warrants all products manufactured by it to
be free from defects in workmanship or material for a
period of one (1) year from date of startup, provided
that in no event shall this warranty extend more than
eighteen (18) months from the date of shipment from
Viking. If, during said warranty period, any products
sold by Viking prove to be defective in workmanship
or material under normal use and service, and if such
products are returned to Viking’s factory at Cedar
Falls, Iowa, transportation charges prepaid, and if
the products are found by Viking to be defective in
workmanship or material, they will be replaced or
repaired free of charge, FOB. Cedar Falls, Iowa.
Viking assumes no liability for consequential
damages of any kind and the purchaser by acceptance
of delivery assumes all liability for the consequences of
the use or misuse of Viking products by the purchaser,
his employees or others. Viking will assume no field
expense for service or parts unless authorized by it in
advance.
Equipment and accessories purchased by Viking
from outside sources which are incorporated into any
Viking product are warranted only to the extent of and
by the original manufacturer’s warranty or guarantee,
if any.
THIS IS VIKING’S SOLE WARRANTY AND IS IN
LIEU OF ALL OTHER WARRANTIES, EXPRESSED
OR IMPLIED, WHICH ARE HEREBY EXCLUDED,
INCLUDING IN PARTICULAR ALL WARRANTIES
OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE. No officer or employee of
IDEX Corporation or Viking Pump, Inc.. is authorized
to alter this warranty.
SECTION TSM
PAGE
ISSUE
When installing the bushings, extreme care must be taken
to prevent breaking. The additional precautions listed below
must be followed for proper installation:
• A press must be used for installation.
• Use Loctite® #4203 or #411 on the outside of the bushing
to hold the bushing in the housing.
• Be certain that the bushing is straight. The groove in the
bushing should line up with the groove in the casing.
• Do not stop the pressing operation until the bushing is in
the proper position; starting and stopping may result in a
cracked bushing.
• Check the bushing for damage after installation.
Installation of PEEK® Bushings
PEEK ® is a trademark of Victrex PLC
Loctite® is a trademark of Henkel Consumer Adhesives, Inc.