Viking Pump TSM615: In-line Gear Reducers - Manual

SECTION TSM 615
PAGE
1 OF 5
ISSUE I
VIKING PUMP, INC. • A Unit of IDEX Corporation •
Cedar Falls, IA 50613 USA VIKING PUMP, INC. • A Unit of IDEX Corporation •
Cedar Falls, IA 50613 USA
TECHNICAL SERVICE MANUAL
CONTENTS
FIGURE 1
SIZE 22 WITH NEMA C-FACE ADAPTOR
FIGURE 2
SIZE 32 WITH SOLID INPUT SHAFT
Introduction ............................................................................. 1
Storage ................................................................................... 2
Lubrication .............................................................................. 2
Oil Quantity
Periodic Oil Changes
Plug Locations ........................................................................ 3
Radial and Overhung Loads ................................................... 3
Troubleshooting ...................................................................... 4
Repair Parts............................................................................ 4
Warranty ................................................................................. 5
CAUTION !
To avoid oxidation and possible seizure of the
motor shaft to the NEMA-C or IEC motor flange
adaptor bore, apply an anti-seize product to the
motor shaft prior to assembly.
DANGER !
Before removing any Viking reducer from
its unit be sure: that the driving means (motor,
turbine, engine, etc.) has been “locked out”
or made non-operational so that it cannot
be started while work is being done on the
reducer or driven equipment.
Failure to follow above listed precautionary
measures may result in serious injury or death.
DANGER !
Incorrect installation, operation or maintenance
of equipment may cause severe personal injury
or death and/or equipment damage.
This information must be read fully before
beginning installation, operation or mainten-
ance and must be kept with the reducer. It is
suggested that suitably trained or qualified
persons perform all installation and mainten-
ance procedures.
Electronic copies of the most current TSM issue can be found on the Viking Pump website at www.vikingpump.com
Viking® In-Line Helical Gear Reducers
Sizes 12, 22, 32, 36, 41, 51, 61, 70, 80, 90, 100
INTRODUCTION
The illustrations used in this manual are for identification
purposes only. This manual deals only with in-line reducers.
Speed reducer specifications and recommendations are listed
in Catalog Section 615, In-Line Helical Gear Reducers.