Viking Pump TSM750: M10 Power Load Monitor - Manual (Page 8)

PAGE 7 OF 7 ISSUE A SECTION TSM 750
DISMANTLING AND DISPOSAL
The housing is made of recyclable plastic, PC/ ABS
and the circuit board contains small amounts of tin and
lead. When disposing, the parts must be handled and
recycled in accordance with local regulations .
EU (EUROPEAN UNION) SPECIFICATIONS
EMC EN 50081- 1, EN 50081- 2,
EN 50082- 1, EN 61000- 6- 2
Electrical safety IEC 947- 5- 1
Rated insulated voltage 690 V
Rated impulse withstand voltage 4000V
Pollution degree 2
Terminals 5, 6, 7 and 8 are basic insulated from the
line.
US SPECIFICATIONS
FCC (Federal Communications Commission)
This equipment has been tested and found to comply
with the limits for a class A digital device pursuant to
the Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when the
equipment is operated in a commercial environment.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
harmful interference, in which case, the user will be
required to correct the interference at their own
expense.
CANADA SPECIFICATIONS
DOC (Department of communications)
This digital apparatus does not exceed the Class A
limits for radio noise emissions from digital apparatus
as set out in the Canadian interference- Causing
Equipment Regulations. Le présent appareil numérique
n'ément pas de bruits radio- électriques dépassant les
limites applicables aux appareils numériques de la
Classe A prestite dans le Régelement sur le brouillage
radioélectrique édicté du Canada.
WARRANTY
Viking warrants all products manufactured by it to
be free from defects in workmanship or material for a
period of one (1) year from date of startup, provided
that in no event shall this warranty extend more than
eighteen (18) months from the date of shipment from
Viking. If, during said warranty period, any products
sold by Viking prove to be defective in workmanship
or material under normal use and service, and if such
products are returned to Viking’s factory at Cedar
Falls, Iowa, transportation charges prepaid, and if the
products are found by Viking to be defective in
workmanship or material, they will be replaced or
repaired free of charge, FOB. Cedar Falls, Iowa.
Viking assumes no liability for consequential
damages of any kind and the purchaser by
acceptance of delivery assumes all liability for the
consequences of the use or misuse of Viking
products by the purchaser, his employees or others.
Viking will assume no field expense for service or
parts unless authorized by it in advance.
Equipment and accessories purchased by Viking
from outside sources, which are incorporated into
any Viking product, are warranted only to the extent
of and by the original manufacturer’s warranty or
guarantee, if any.
THIS IS VIKING’S SOLE WARRANTY AND IS IN
LIEU OF ALL OTHER WARRANTIES,
EXPRESSED OR IMPLIED, WHICH ARE HEREBY
EXCLUDED, INCLUDING IN PARTICULAR ALL
WARRANTIES OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE. No
officer or employee of IDEX Corporation or Viking
Pump, Inc. is authorized to alter this warranty.
VIKING PUMP, INC. ● A Unit of IDEX Corporation ●
Cedar Falls, IA 50613 USA ©2002
SECTION TSM 750
PAGE
8 OF 8
ISSUE B
VIKING PUMP, INC. • A Unit of IDEX Corporation •
Cedar Falls, IA 50613 USA
© 3/2013 Viking Pump Inc.
All rights reserved
TECHNICAL SERVICE MANUAL
WARRANTY
Viking warrants all products manufactured by it to be
free from defects in workmanship or material for a
period of one (1) year from date of startup, provided
that in no event shall this warranty extend more than
eighteen (18) months from the date of shipment from
Viking. The warranty period for Universal Seal series
pumps ONLY (Universal Seal models listed below) is
three (3) years from date of startup, provided that in
no event shall this warranty extend more than forty-two
(42) months from the date of shipment from Viking.
UNDER NO CIRCUMSTANCES SHALL VIKING BE
LIABLE UNDER THIS WARRANTY OR OTHERWISE
FOR SPECIAL, INCIDENTAL, INDIRECT,
CONSEQUENTIAL OR PUNITIVE DAMAGES OF ANY
KIND, INCLUDING, BUT NOT LIMITED TO, LOST
OR UNREALIZED SALES, REVENUES, PROFITS,
INCOME, COST SAVINGS OR BUSINESS, LOST OR
UNREALIZED CONTRACTS, LOSS OF GOODWILL,
DAMAGE TO REPUTATION, LOSS OF PROPERTY,
LOSS OF INFORMATION OR DATA, LOSS OF
PRODUCTION, DOWNTIME, OR INCREASED
COSTS, IN CONNECTION WITH ANY PRODUCT,
EVEN IF VIKING HAS BEEN ADVISED OR PLACED
ON NOTICE OF THE POSSIBILITY OF SUCH
DAMAGES AND NOTWITHSTANDING THE FAILURE
OF ANY ESSENTIAL PURPOSE OF ANY PRODUCT.
THIS WARRANTY IS AND SHALL BE VIKING’S SOLE
AND EXCLUSIVE WARRANTY AND SHALL BE IN
LIEU OF ALL OTHER WARRANTIES, EXPRESS
OR IMPLIED, INCLUDING, BUT NOT LIMITED
TO, ALL WARRANTIES OF MERCHANTABILITY,
FITNESS FOR A PARTICULAR PURPOSE AND
NON-INFRINGEMENT ALL OF WHICH OTHER
WARRANTIES ARE EXPRESSLY EXCLUDED.
See complete warranty at www.vikingpump.com.
POWER LOAD MONITOR
MOTOR SHAFT OUTPUT POWER MEASUREMENT