Weller WX2 - Manual (Page 38)

14-20 WX 2
Fig. 17
Fig. 19
Fig. 20
Fig. 18
Set the temperature deactivation value (standby time)
When the soldering tool is not in use, the temperature is reduced to
the standby temperature after the set standby time has elapsed.
Standby mode is indicated as a flashing actual value and the display
reads "Standby" (20).
Press control key 1, 2, 3 or 4 to exit Standby mode. The sensor
integrated tool detects the change in state and deactivates Standby
mode as soon as the tool is moved.
Setting the standby time:
1. Call up the parameter menu.
2. Select and confirm the menu option Standby time.
3. Set the required standby time with the turn-and-click wheel (7).
The following standby settings are possible:
− "OFF" = "0 min": standby time is deactivated (factory setting)
− "ON" = "1-99 min": standby time, individually adjustable
4. Confirm the value with the Enter key (8).
Select further setting parameters in the menu
or
exit the parameter menu with key 6.
Note In the case of soldering work with low heat requirements, the
reliability of the standby function may be impaired.
Setting the automatic switch-off time (AUTO-OFF)
When the soldering tool is not in use, the soldering tool
heater is switched off when the AUTO OFF time expires.
Temperature deactivation is performed independently of the set
standby function. The actual temperature is indicated by flashing
LED and serves as a residual heat display. The display reads
"OFF" (19).
1. Call up the parameter menu.
2. Select and confirm the menu option AUTO-OFF time .
3. Set the required AUTO-OFF time with the turn-and-click wheel
(7).
The following AUTO-OFF time settings are possible:
− "OFF" = "0 min": AUTO OFF function is deactivated (factory
setting)
− "ON" = "1-999 min": AUTO-OFF time, can be set individually.
4. Confirm the period with the Enter key (8).
Select further setting parameters in the menu or
exit the parameter menu with key 6 .
Note To reset the STANDBY and AUTO-OFF modes:
Press control key 1, 2, 3 or 4 (if no tool holder is in use) or remove
the soldering tool from the holder.