Canon DR-9080C - Manual (Page 64)

60
Chapter 5 Other Functions
Setting in the User Mode
You can select the mode of operation (user mode) for the scanner from those
listed below.
● Operation panel buzzer setting
U01-0 Do not sound buzzer during key operation.
U01-1 Sound buzzer during key operation (default).
● Count Only mode setting
U02-0 Do not use the endorser in the Count Only mode (default).
U02-1 Use the endorser in the Count Only mode.
● Endorser Stamp mode setting
U03-0 Use the endorser in the check mode (default).
U03-1 Use the endorser in the A4 mode.
● Double feed detection control settings in the Count Only mode
U04-0 Do not detect double feed in the Count Only mode (default).
U04-1 Detect double feed in the Count Only mode.
● Staple detection settings in the Count Only mode
U05-0 Do not detect staples in the Count Only mode (default).
U05-1 Detect staples in the Count Only mode.
● Staple detection accuracy settings
U06-0 Low level accuracy staple detection.
U06-1 Medium level accuracy staple detection (default).
U06-2 High level accuracy staple detection.
● Imprinter control settings in the Count Only mode
U07-0 Do not use the imprinter in the Count Only mode (default).
U07-1 Use the imprinter in the Count Only mode.
● Skew detection control settings in the Count Only mode
U08-0 Do not use skew detection in the Count Only mode.
U08-1 Use skew detection in the Count Only mode (default).
● Energy-saving mode setting
U09-0 Do not go into energy-saving mode.
U09-1 Go into energy-saving mode after 10 minutes of no operation
(default).