Canon DR-9080C - Manual (Page 81)

77
6
Error code J02
Cause Staple detected, document feed stopped.
Remedy Open the upper scanner and remove the document. Check to see if
the document was scanned correctly, and scan the document
again.
Error code J18
Cause Detected a skewed document, document feed stopped.
Remedy Open the upper scanner and remove the document. Check to see if
the document was scanned correctly, and scan the document
again.
Error code P00
Cause Document detected in the scanner when the power was turned
ON or the upper scanner was open.
Remedy Remove the document that was left in the scanner. (See p.67.)
Error code P02
Cause Detected a document that is longer than the document that is
set.
Remedy Open the upper scanner and remove the document. Check to see if
the document was scanned correctly, and scan the document
again.
Error code P03
Cause Detected a document that is shorter than the document that is
set.
Remedy Open the upper scanner and remove the document. Check to see if
the document was scanned correctly, and scan the document
again.
Error code P30
Cause Endorser ED600 paper jam
Remedy Clear the paper jammed from inside the optical endorser ED600,
according to the instructions in the Endorser ED600 Instructions.
Error code U01
Cause Number of document sheets to be scanned exceeds set
number of sheets in the verify scan.
Remedy Two or more sheets may have been fed when the number of sheets
is counted. Press the [Stop] key to reset the counter to “0.” Check
the number of sheets to see if all document sheets have been
counted, and scan the document again.
6.5 When an Error Code Is Displayed