Monarch Instrument DC6000 - Manual (Page 7)

Warnings and Safety Precautions
I.
Page vii
1/06/2012 REV 1.10.2
NOTE
The contents of this manual are correct at the time of issue. The contents may change at any time without prior
notification. This is due to continuous developments to the recorder and its functionality.
1.1 Trademarks

Microsoft, MS-DOS, Windows, Windows 2000, Windows XP and Windows CE are all registered trademarks
of Microsoft Corporation.
 CompactFlash™ and CF (logo) are trademarks of the Compact Flash Association (CFA).
 For the purpose of the manual the ™ and ® symbols will not follow their own trademark names or registered
trademark names.

Company names and Product names mentioned in this manual are trademarks or registered trademarks of
their individual owners.
1.2 Symbols
One or more of the following symbols may appear on the recorder labeling.
Refer to manual for instructions see Section 1.3 below.
Caution - Risk of electric shock
Earth (ground) terminal
Directive 2002/96/EC WEEE: Waste Electrical and Electronic Equipment
1.3 Warning and Safety Notice
This Safety Notice has been included to emphasize the DANGER OF HAZARDOUS VOLTAGES on
the REAR TERMINAL PANEL of your instrument. USE EXTREME CAUTION WHEN INSTALLING
OR SERVICING your instrument. Please read the warnings below and the entire contents of
Section 3
– “Installation and Wiring” within this manual before attempting to install or service your
instrument.
1. Before any connections are made to the recorder, ensure the protective earth terminal is connected to a
protective conductor. The chassis ground terminal is indicated thus -
WARNING
This warning sign on the unit cautions the user to read this manual to determine the nature
of the hazard and any precautions which should be taken.
Any interruption of the protective conductor inside or outside the recorder, or disconnection of the
protective earth terminal is likely to make the recorder dangerous under some fault conditions.
Intentional interruption is prohibited.
NOTE: In order to comply with the requirements of safety standard EN61010, the recorder must have
one of the following as a disconnecting device, located within easy reach of the operator, and be
labeled as the disconnecting safety device:

A switch or circuit breaker which complies with the requirements of IEC 60947-1 and IEC 60947-3