Wheatheart GHR 80/100 x 31-71ft Augers EMD - Manual (Page 29)

W HEATHEART - G RAIN A UGER EMD 3. A SSEMBLY
GHR 80 X 31’-71’ & 100 X 31’-71’ 3.10. T RANSPORT U NDERCARRIAGE
30642 R0 29
Note: Installing tires may not leave you with enough clearance to position and attach
undercarriage once auger tube is raised. If so, install wheels after assembly is
complete.
g. Install tires and tubes on the rims provided. Inflate according to recommen-
dation on tire side-wall. Wheels may be mounted on hubs at this time with
six 1/2” x 1-3/4” wheel bolts.
7. Fasten upper lift
arms to lower
reach arms with
5/8” x 1-1/2” bolts
and locknuts. Do
not overtighten.
Tighten snug
only. These bolts
act as pivot
points.
• The 8" x 56’-
61’-71' and the
10" x 51’-61’-
71' augers
require
3/4” x 2" bolts
and locknuts.
8. Raise the
discharge end of auger with a front end
loader and a strong sling / chain or block
and tackle. The height should be sufficient
to clear undercarriage assembly.
WARNING
Do not remove tube support until auger is fully
assembled.
Figure 3.17
¨