Wheatheart GHR 80/100 x 31-71ft Augers EMD - Manual (Page 36)

3. A SSEMBLY W HEATHEART - G RAIN A UGER EMD
3.13. P LASTIC M ANUAL H OLDER GHR 80 X 31’-71’ & 100 X 31’-71’
36 30642 R0
7. Place electric motor on mount and
secure. Do not tighten.
8. Place belts on pulleys and apply
slight tension. Align the 2 pulleys
(use a straight edge). Tighten
motor bolts and pulley set screws.
Once all bolts and set screws are
tightened, re-check alignment.
Proper alignment will prolong belt life.
9. Adjust the plastic pulley guard
backplate to make sure it will not
rub on the electric motor shaft.
Tighten backplate mount bolts/
nuts securely.
10. Close and lock plastic pulley
guard into place (Figure 3.31).
3.13. PLASTIC MANUAL HOLDER
Before beginning installation, ensure that all
winch / auger lift controls are locked in place
and shut down and/or lock out auger.
1. Attach holder to the lower frame arms.
Manual holder must be accessible at all
times, whether frame is up or down.
2. The manual holder cap must face up
(towards the intake end). Attach manual
holder with supplied zip ties. Tighten the zip
ties, securing the holder in place.
Where possible, attach the zip ties around a
frame brace tab to prevent the manual holder
from slipping down the lower frame arms.
When using an electric motor:
• The motor and controls should be installed by a qualified electrician in
accordance with all local and national codes.
• Incorporate a magnetic starter to protect the motor.
• The motor must have a manual reset button.
• Locate reset and starter controls so that the operator has full view of the
entire operation.
• Locate main power disconnect switch within reach from ground level to
permit ready access in case of an emergency.
• A main power disconnect switch capable of being locked (in the off posi-
tion only) must be provided.
Figure 3.31
Note:
LOWER
REACH
ARMS
PLASTIC
ZIP TIES
CAP FACIN
G
INTAKE
Figure 3.32
Note: