Wheatheart GHR 80/100 x 31-71ft Augers EMD - Manual (Page 31)

W HEATHEART - G RAIN A UGER EMD 3. A SSEMBLY
GHR 80 X 31’-71’ & 100 X 31’-71’ 3.10. T RANSPORT U NDERCARRIAGE
30642 R0 31
c. Next, fasten flat
braces (B) to first
set of holes
(furthest from
intake) on
stabilizer braces
(A) with one
7/16” x 1-3/4”
bolt and locknut.
Place one
7/16” x 1" bolt
and locknut in
the other hole of
the stabilizer
brace.
Important: Where applicable, make sure that the lower reach arms are attached to the
proper reach arm bracket (Figure 3.13, 3.14).
11. Attach upper lift arms to roller track shoe with one 5/8” x 6-1/2” bolt and
locknut. Do not overtighten. Tighten snug only; this bolt acts as a pivot point
(Figure 3.20).
¨
• The 8" x 56’-61’-71' and the 10" x 51’-61’-71' augers require a
3/4” x 6-1/2” bolt and locknut.
¨
12. The 8" x 56’-61’-71' and the 10"
x 51’-61’-71' augers require
additional tubing cross braces
mounted to the upper lift arms.
• The correct assembly
method is to slip the tube
clamps over the flat pressed
ends of the lift arms (where
they are attached to the
frame) and loosely attach the
tubing cross braces to the
tube clamps using five 1/2” x
1-1/4” bolts and locknuts.
Figure 3.20
Figure 3.21