Wheatheart WHR 130 x 41ft Auger PTO-SD - Manual (Page 11)

WHEATHEART - GHR & WHR GRAIN AUGERS 2. S AFETY F IRST
GRAIN AUGERS 2.5. E LECTRIC M OTOR S AFETY
30661 R2 11
2.5. ELECTRIC MOTOR SAFETY
• Inspect the drive belts before using auger. Replace if frayed or damaged.
• Do not grab or touch drive belts during operation for any reason.
• Remember to ground electric motor before using auger.
2.6. TRANSPORT & PLACEMENT SAFETY
• Transport auger in full down position with slight ten-
sion on cable.
• Properly place hitch pin and securely attach safety
chain. Use a type of hitch pin that will not allow
auger to separate from towing vehicle.
• Always attach an SMV (slow moving vehicle) sign
before transporting auger. Equip the auger with the
necessary lights for transportation where required
by law. Always use hazard warning flashers on the
tractor/towing vehicle when transporting unless
prohibited by law.
• Always travel at a safe speed, never exceeding 15
mph (24 km/hr). Reduce speed on rough surfaces
and be cautious when turning corners or meeting
traffic.
• Before raising/lowering/moving the auger, make
sure the area around the auger is clear of obstruc-
tions and/or untrained personnel. Never allow any-
one to stand on or beneath auger while
transporting or placing auger.
• Do not transport auger on slopes greater than 20°.
• Wheels must be free to move when raising or low-
ering auger.
• Never attempt to move auger manually. To do so
will result in serious injury.
• Before moving auger, check for overhead obstructions and/or electrical wires.
Electrocution can occur without direct contact.
• When lowering the auger the track shoe may become stuck; if this happens,
do not continue to turn the winch handle counter-clockwise because it will dis-
engage the brake mechanism and will create an unsafe condition. Too much
slack in the cable may also cause the auger to drop suddenly.
• Disconnect PTO driveline from tractor before moving auger or tractor and
secure in transport saddle (where applicable).
• The winch must make a clicking sound when raising auger. If clicking sound
stops, retain grip on handle, lower auger fully, and repair winch.
• Always keep a minimum of 3 cable wraps on the winch drum.