Wheatheart WHR 130 x 41ft Auger PTO-SD User Manual
Page 21
WHEATHEART - GHR & WHR GRAIN AUGERS
3. A
SSEMBLY
GRAIN AUGERS
3.6. EMD D
RIVE
30661 R2
21
Figure 3.8
16. Attach the guard to gearbox assembly by bolting the guard mount bracket to
the short angle with one 3/8" x 3/4" bolt and washer locknut.
17. Secure the other end of guard by bolting the “wide” guard mount angle to the
“narrow” guard mount angle with two 5/16" x 5" bolts and locknuts. Adjust the
width of guard at the motor pulley to suit the pulley diameter.
When using an electric motor:
• The motor and controls should be installed by a qualified electrician in
accordance with all local and national codes.
• Incorporate a magnetic starter to protect the motor.
• The motor must have a manual reset button.
• Locate reset and starter controls so that the operator has full view of the
entire operation.
• Locate main power disconnect switch within reach from ground level to
permit ready access in case of an emergency.
• A main power disconnect switch capable of being locked (in the off posi-
tion only) must be provided.