Wheatheart WHR 130 x 41ft Auger PTO-SD - Manual (Page 31)

WHEATHEART - GHR & WHR GRAIN AUGERS 4. T RANSPORT & P LACEMENT
GRAIN AUGERS 4.2. P LACEMENT P ROCEDURE
30661 R2 31

PTO Models Only: The driveline is non-separable. Remove from tractor and
secure in transport saddle on auger before moving tractor away from auger.
6. Move the auger into working position slowly. Do not unhitch and attempt to
move auger by hand.
7. Once auger is in position, chock wheels on both sides and apply the park
brake on the tractor (or chock its wheels as well) to prevent movement during
operation.
Important: When releasing auger from the towing vehicle, test the intake end for downward
weight. Do not raise the intake end above drawbar height. When the intake end
is elevated too high with auger in raised position, the balance of weight quickly
transfers to the discharge end, causing it to upend. Ensure proper anchoring/
support.
8. When operating auger in the raised position, rest the discharge end lightly on
the bin roof, or tie to bin to prevent wind from toppling auger. When operating
the auger in a freestanding position, anchor the intake end.
9. Anchor and/or support auger during operation.
• When lower half of auger empties of grain, the weight balance transfers
to upper end of auger, which can cause upending.
10. See “Lowering & Completion” on page 37 for correct lowering procedure.
WARNING
Never attempt to increase height of auger by
positioning wheels on lumber, clocks, or by
any other means. To do so will result in
damage to equipment and/or personal injury.
CAUTION
Do not use auger as a hoist to raise any object
regardless of weight. This will create an
unsafe condition and will void warranty.