Great Plains 30-Foot High Clearance Full Press Drill 1983-1985 Parts Manual - Manual (Page 29)

Revision Comments Part Description Part No. Ref.
Image No. dwg18201 1.
U JOINT SPINDLE RH 125-001H 2.
Shown U JOINT SPINDLE LH 125-002H 2.
SEAL 3.375 X 2.0 X.438 CR20125 816-012C 3.
BEARING CONE 25590 822-014C 4.
BRG CUP 25520 822-013C 5.
BEARING CUP 25821 822-015C 6.
BEARING CONE 25877 822-016C 7.
2nd rev. WASHER SPINDLE - 7/8 804-055C 8.
1st rev. WASHER FLAT 7/8 SAE PLT 804-026C 8.
NUT HEX SLOTTED 7/8-14 PLT 803-029C 9.
PIN COTTER 3/16 X 1 1/4 PLT 805-016C 10.
HUB CAP 890-032C 11.
GREASE ZERK STRAIGHT 1/4-28 800-001C 12.
HC TRIANGLE FRAME 128-003H 13.
SLIDE FRAME SPREADER TUBE 104-008D 14.
HHCS 1/2-13X6 GR5 802-047C 15.
WASHER LOCK SPRING 1/2 PLT 804-015C 16.
NUT HEX 1/2-13 PLT 803-020C 17.
HHCS 1-8X8 GR5 802-076C 18.
WASHER LOCK SPRING 1 PLT 804-027C 19.
NUT HEX 1-8 PLT 803-031C 20.
PIN HITCH 1 X 6 W/HAIRPIN 805-033C 21.
TONGUE PIN ASSEMBLY 114-013H 22.
PIN LINCH 5/16 X 1 3/4 805-015C 23.
1983-1985. LOCK HANDLE WELDMENT 124-016H 24.
1983-1985. PIN ROLL 1/4 X 3/4 PLT 805-026C 25.
1983-1985. SPRING LEVER 807-007C 26.
1983-1985. SPRING LEVER WELDMENT 124-017H 27.
1983-1985. PIN LOCK PIVOT PIN 124-105D 28.
1983-1985. PIN LOCK WELDMENT 124-018H 29.
1983-1985. PIN SPIROL 1/2X2 1/2 PLAIN 805-037C 30.
12/26/12 - 29 - 129-035P
Table of Contents Part Number Index
Frame
Main Frame And Slide Assembly
(Applies to HCF30 (1980-1985) only)