Great Plains 3P300 Operator Manual - Manual (Page 37)

Great Plains Manufacturing, Inc. Operations 33
09/14/2009 500-103M-A
Main Water Fill Using Sprayer’s Pump
Note: Use of the sprayer’s own pump to fill the tank is pos-
sible only when the optional inductor is installed.
Tank Fill relies on valves and plumbing supplied
with the inductor.
Refer to Figure 17, Figure 18, and Figure 13 on page 29
Note: The sprayer’s own hydraulic or PTO pump is a cen-
trifugal type, and may be run with downstream
valves closed.
Note: The sprayer’s own hydraulic or PTO pump may re-
quire priming if the water level at the source has no
pressure and is below the sprayer.
Steps 1 and 2 are on page 32.
3. Close the ball valve at the main tank inlet.
4. Set Agitator valve to OFF.
5. Set Manual Throttle valve to ON.
6. Set tank Left Sump valve to REAR
(selecting hose from inductor).
7. Set inductor Product valve to TANK FILL.
8. Connect the supply hose to the quick-fill Cam-Lock
coupler
.
9. Turn on the water.
10. Open the quick-fill ball valve .
11. Start the sprayer pump.
12. Stop filling by first stopping the pump, then closing
the inlet valve .
Figure 17
Sump Valve for Self-Fill
15920
6
3
4
6
1
2
3
4
6
6
Figure 18
Product and Inductor Valves
15802
4
5
6