Great Plains 3N-4020 Operator Manual User Manual
Operator manual, Manufacturing, inc
Advertising
Manufacturing, Inc.
© Copyright 2013
Printed 2013-10-29
196-359M
EN
ORIGINAL INSTRUCTIONS
Operator Manual
3N-4010F, 3N-4010HDF and 3N-4020F
3-Section 40-Foot No-Till Drills
Read the operator manual entirely. When you see this symbol, the
subsequent instructions and warnings are serious - follow without
exception. Your life and the lives of others depend on it!
Illustrations may show optional equipment not supplied with standard unit or may
depict similar models where a topic is identical.
20476
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Operator Manual
- Table of Contents
- Important Safety Information
- Look for Safety Symbol
- Be Aware of Signal Words
- Prepare for Emergencies
- Be Familiar with Safety Decals
- Wear Protective Equipment
- Handle Chemicals Properly
- Avoid High Pressure Fluids
- Check for Overhead Lines
- Keep Riders Off Machinery
- Use Safety Lights and Devices
- Transport Machinery Safely
- Shutdown and Storage
- Practice Safe Maintenance
- Tire Safety
- Safety At All Times
- Safety Decals
- Safety Reflectors and Decals
- 818-055C Slow Moving Vehicle Reflector
- 838-266C Red Reflectors
- 838-265C Amber Reflectors
- 838-267C Daytime Reflectors
- 818-557C Danger: Cannot Read English
- 818-590C Danger: Crushing Hazard
- 838-102C Danger: Falling Hazard
- 818-045C Warning: Pinch/Crush
- 818-188C Warning: Speed Hazard
- 818-339C Warning: High Pressure Fluid Hazard
- 818-579C (Option) Warning: Pinch Point
- 818-580C (Option) Warning: Overhead Hazard
- 818-398C Caution: Tires Not A Step
- 818-587C Caution: General
- 838-426C Caution: Pressure/Torque
- Introduction
- Preparation and Setup
- Operating Instructions
- Hydraulic Drive Operation
- Adjustments
- Planting Depth
- Frame Level
- Frame Height
- Frame Height without Frame-Mounted Coulters
- Frame-Mounted Coulters
- Row Unit Shut-Off
- Implement Lift Switch Adjustment
- Frame Weight
- Marker Adjustments
- 10 Series Row Unit Adjustments
- 10HD Series Row Unit Adjustments
- 20 Series Row-Unit Adjustments
- Troubleshooting
- Maintenance and Lubrication
- Welding
- Seed Cleanout
- Frame Alignment and Level
- Tongue Spacer Block
- Bleeding Hydraulics
- Marker Maintenance
- Electric Clutch Lockup
- Hydraulic Drive Maintenance
- Row Unit Maintenance
- Lubrication
- Grease Bank (Option)
- Parallel Arm Pivots
- Wing Caster Wheel Pivot
- Rockshaft
- Lift Cylinder Pins
- Wing Flex Pivots
- Rear Axle Pivot
- Transfer Drive Shafts
- Wing Frame Vertical Pivots
- Marker(s) (Option)
- 20 Series Side Gauge Wheel Bushings
- Rear Wheel Caster Spindles
- Drive Chains
- Coulter Hub Bearings
- Marker Disk Bearings (Option)
- Wheel Bearings
- Options
- Appendix
- Index