Ag leader pf3000, Pf3000 settings – Great Plains 3N-4020 Operator Manual User Manual
Page 61
Great Plains Manufacturing, Inc.
Hydraulic Drive Operation
57
2013-10-29
196-359M
Ag Leader PF3000
Settings for Ag Leader PF3000 Monitors used with Preci-
sion Population Controller QUICK REFERENCE GUIDE.
1.
Create a .tgt recipe file in SMS 2.0 or FarmWorks
Site Pro, or other software that will create a .tgt file,
and copy it to an SRAM or Flash card that is compat-
ible with the PF 3000.
PF3000 Settings:
2.
Press SETUP key.
Press SWATH key.
Set swath to that of your Great Plains Precision
Seeding System.
3.
Press SETUP key.
Press VEHICLE key.
Set Primary speed sensor to GPS.
4.
Press SETUP key.
Press CARD key.
Set the following:
• Log Device: None.
5.
Press SETUP key.
Press APP RATE key.
Set the following:
• Application Control: On
• Look Ahead: On
• Current target file: press Edit to view the files you
have on the card; select the one you wish to use.
6.
Press SETUP key.
Press CONTROLLER key.
Select controller as Rawson Accu-Rate.
Press EDIT SETTINGS. Set the following:
• Number of pulses/10 revolutions: 500
• Nominal rate: Divide the highest rate on your rec-
ipe by 1.6. This is your Nominal rate. If your high-
est rate is 32, your nominal rate is 20.
• Percent rate change: set to 4%
• Area count: Set to Standard
• Stop height: Set to 8
• Act. rate recording method: Set to Sensor
• Controller time delay: Set to 4 sec.
• Application offset from GPS:
24 ft (7.32m)
Add the distance from the hitch pin to your GPS
location.
• Serial Port: Port 3
7.
Press SETUP key.
Press PRODUCT key.
Select product and press EDIT SETTINGS.
Set the following:
• Controller Device: Rawson Accu-RateCal. number
for act. rate: set to 0
• Actual Rate Scale Factor: Set to 1.000
• Target Rate Units: Set to Seeds
• Actual Rate Units: Set to Seeds
• Target conversion Number: 1
• Target Rate increment: Determines the increment
value by which you can change the manual target
rate with each press of the arrow keys.
8.
Press FIELD key.
Set Field.
Set Product (press button to right of product)
Figure 83: PF3000:
Serial Connection to Controller
28322
1