20 series disk adjustments, Opener disc contact region, Adjusting disc contact – Great Plains 3N-4020 Operator Manual User Manual

Page 90: Side gauge wheel adjustments

Advertising
background image

86

3N-4010F/3N-4010HDF/3N-4020F

Table of Contents

Index

Great Plains Manufacturing, Inc.

196-359M

Table of Contents

Index

2013-10-29

20 Series Disk Adjustments

See also “20 Series Opener Maintenance” on page
112.

Opener Disc Contact Region
Refer to Figure 130

Opener disc angle and stagger is not adjustable, but
disc-to-disc spacing is, and may need attention as discs
experience normal wear. Spacers will need to be reset
when blades are replaced.

The ideal spacing causes the blades to be in contact for
about one inch

. If you insert two pieces of paper

between the blades, they should slide to 0.5 to 1.75in (13
to 44mm) of each other.

If the contact region is significantly larger or smaller (or
there is no contact at all), it needs to be adjusted by mov-
ing one or more spacer washers.

Adjusting Disc Contact
Refer to Figure 130
and Figure 131

1.

Raise the drill.

2.

Remove the side gauge wheels

on the row unit in

need of adjustment.

3.

Remove the bolt

retaining the opener disc

on

one side. Carefully remove the disc. Do not lose the
hub components and spacer washers

,

.

4.

To reduce the spacing between the discs (the normal
case), move one spacer washer from the inside

to

the outside

of the disc.

5.

Re-assemble and check disc contact.

Side Gauge Wheel Adjustments

Refer to Figure 132

The side gauge wheels have two, interrelated adjust-
ments:

• angle of side gauge wheel, and

• distance between side gauge wheels and disks.

Refer to Figure 133

Adjust side-gauge-wheel angle so wheels contact
row-unit disks at the bottom of wheel at 2in planting
depth and gaps open

3

8

to

5

8

in at top. Check with

row-units in soil so wheels are held up.

At the same time, keep side gauge wheels close to
opener disks so openers do not plug with soil or trash.
However, wheels should be out far enough so disks and
wheels turn freely.

Figure 130

Opener Disc Contact Region

26127

1

2

1

Figure 131

Opener Disc Spacers

26128

6

5

3

4

2

3

4

5

6

5

6

Incorrect

Correct

Figure 132: 20 Series:

Disk/Gauge Wheel Alignment

Side Gauge
Wheel

Opener
Disks

Side Gauge
Wheel

Advertising
This manual is related to the following products: