Materials clean-out, Main box clean-out, Fertilizer box clean-out – Great Plains 1300 13-Foot Operator Manual User Manual

Page 33: Main box clean-out fertilizer box clean-out, Materials clean

Advertising
background image

Great Plains Manufacturing, Inc.

Table of Contents

Index

Operating Instructions

29

2014-04-15

Table of Contents

Index

175-157M

Materials Clean

-

Out

Main Box Clean

-

Out

Refer to Figure 24, which depicts the seed cup door handle
in a normal operating position

.

1.

Set the Seed Rate Handle to zero (0) for the section
of the drill to be cleaned out. This moves the seed
cup sprockets out of the seed path.

2.

Position a tarp or bucket under each row or set of
rows to be cleaned out.

3.

At the seed cup for that row, pull the door handle
out of the operating detent range, and swing it down
to position

.

4.

Open the main seed box and use a small brush to
sweep seed toward seed cups set to clean-out. If
seed does not flow freely, inspect seed cup, hose
and seed tubes for obstructions.

5.

Wash out the seed box with high pressure water.

It is not necessary to operate the seed meter drive shaft
for clean-out. With the Seed Rate set to zero, nothing
moves inside the seed cups; however, an inspection of
the flutes for excess wear and damage does require
shaft rotation.

Set the Seed Rate Handles to 100 and disengage the
lock-out hub. With openers lowered to engage the clutch,
the seed meter jackshaft can be slowly turned with the
calibration crank, while another person inspects the
flutes from the open seed boxes.

Fertilizer Box Clean-Out

After applying fertilizer, clean drill boxes as soon as
possible. Fertilizers often contain chemicals corrosive to
metal.

Refer to Figure 25
With a small scoop or can, remove as much fertilizer as
possible from drill boxes.

Clean-out releases material across the entire length of a
section box. Have collection equipment prepared.

Release all clean-out latches on a drill section, and open
clean-out door. Leave door open until after washout.

Refer to Figure 26
Wash inside of drill boxes with water under high
pressure. To aid clean out, lift vinyl dew shield and spray
into fertilizer trays (with clean-out door open).

Let drill boxes dry before closing clean-out doors.

1

2

Figure 24

Seed Cup Clean-out

26211

1

1

2

Figure 25

A Fertilizer Clean-out Latch

16376

Figure 26

Dew Shield at Openings

16382

Advertising