Great Plains 1300 13-Foot Operator Manual - Manual (Page 71)

2014-04-15 Table of Contents Index 175-157M
Great Plains Manufacturing, Inc. Table of Contents Index Appendix B Initial Setup 67
Appendix B Initial Setup
Acremeter Installation
Refer to Figure 48
The acremeter may be supplied for shaft or frame mount.
For shaft mount, see the acremeter manual included with
the drill for installation instructions.
See “Acremeter Operation” on page 27.
Scraper Installation
Optional carbide disk scrapers are not factory installed.
To install them in the field:
1. Remove one or both disk blades to gain safe access
to the mount. Note the position of bushings and
spacers for correct reassembly (page 36).
2. Remove the existing slotted scraper.
Refer to Figure 49
3.
If Seed-Lok
®
is present, or also being mounted, do
not use the hex nut supplied with the scraper, and
place the lock washer under the bolt head.
4. Place the flat washer on the bolt .
5. Insert the bolt through the scraper blades , the
spacer , and the mount . Secure with lock
washer and hex nut (If Seed-Lok
®
is present,
screw bolt into thread hole in Seed-Lok
®
).
6. If the blade spring was not pre-assembled,
connect it between the upper holes of the blades .
7. Tighten bolt .
8. Remount the removed disk blade.
Figure 48
Acremeters
34937
34776
2
1
5
8
3
4
6
7
Figure 49
Scraper Installation
19000
1
2 3
4 3
5
6 7
2 1
8
5
3