Great Plains 1300 13-Foot Operator Manual - Manual (Page 45)

2014-04-15 Table of Contents Index 175-157M
Great Plains Manufacturing, Inc. Table of Contents Index Maintenance and Lubrication 41
Maintenance and Lubrication
General Information
Proper servicing and maintenance is the key to long
implement life. With careful and systematic inspection,
you can avoid costly maintenance, downtime and repair.
Always turn off and remove the tractor key before making
any adjustments or performing any maintenance.
You may be severely injured or killed by being crushed under a
falling implement. Always have frame sufficiently blocked up
when working on, and particularly under implement.
Escaping fluid under pressure can have sufficient pressure to
penetrate the skin. Check all hydraulic lines and fittings before
applying pressure. Fluid escaping from a very small hole can
be almost invisible. Use paper or cardboard, not body parts,
and wear heavy gloves to check for suspected leaks. If an
accident occurs, seek immediate medical attention from a
physician familiar with this type of injury.
After using drill for several hours, check all bolts to be
sure they are tight.
1. Securely block drill before working on it.
2. Lubricate areas listed under “Lubrication” on
page 47.
3. Clean any fittings that do not take grease.
4. Inflate tires as specified on “Tire Inflation Chart” on
page 58.
5. Inspect hydraulic hoses for cuts, cracks and aging.
Check fittings for evidence of leaks.
6. Replace any worn, damaged or illegible safety
decals. Order new decals from your Great Plains
dealer. See “Safety Decals” on page 6.