Marker disk angle adjustment – Great Plains 1300 13-Foot Operator Manual User Manual
Page 37
Advertising
Great Plains Manufacturing, Inc.
Adjustments
33
2014-04-15
175-157M
Marker Disk Angle Adjustment
Sharp Object Hazard:
Use caution when making adjustments in this area. Marker
disks may be sharp.
Refer to Figure 29
To change angle of cut, and the width of the mark, loosen
1
⁄
2
-inch bolts
holding disk assembly.
For a wider mark (W), increase the angle of the marker
with respect to the tube
. For a narrower mark (N),
reduce the angle.
You can also invert the disk blade on the hub to change
the direction of throw.
Tighten bolts
.
Note: The direction of travel (T) tends to drive the disk
angle to Wide. If bolts are not tight enough, or
loosen over time, the disk will slip into the Wide
mark configuration.
Figure 29
Marker Disk Angle
11757
N
W
T
2
1
1
2
1
Advertising