Great Plains NTA3010 Operator Manual - Manual (Page 27)

Great Plains Manufacturing, Inc. Table of Contents Index Operating Instructions 23
2014-03-26 Table of Contents Index 160-219M-A
Lift System Transport Locks
The lift system has transport locks for the rockshaft and
lift-assist cylinders. Use these locks every time you raise
the drill for maintenance, lubrication, folding, transport or
raised parking/storage.
To install the locks:
Refer to Figure 22
1.
Remove the lift-assist locks from the under-edge
of the plate forward of the parallel arms.
Refer to Figure 23
2.
Remove the rockshaft locks from the storage plate
on the implement frame.
3. Raise the drill.
4. Pin the rockshaft locks in place on the lugs of the
rockshaft and main frame
, just inside each center
gauge wheel.
Refer to Figure 24
5.
Pin lift-assist locks over the rods of the lift-assist
cylinders.
6. Lower drill onto locks and set circuit to neutral (or
float, if unhitching or servicing hydraulics).
Figure 22
Lift-Assist Lock Stored
16248
1
1
2
Figure 23
Rockshaft Locked
16165
3
2
3
4
Figure 24
Lift-Assist Locked
16167
4