Great Plains NTA3010 Operator Manual - Manual (Page 34)

30 NTA3010 and NTA3510 Table of Contents Index Great Plains Manufacturing, Inc.
160-219M-A Table of Contents Index 2014-03-26
Refer to Figure 34 through Figure 36
Note: First-time fold: If the drill has markers, make sure
that the Marker Stop Bolt is installed as shown.
Do not fold with markers if this bolt is not present.
The markers will strike drill components and
damage will result.
8. If the wing lock-up pin was stored in the end or
second lock hole , remove it. If it is stored in the
weldment ring , it may be left in place during fold.
9. On the seed monitor terminal in the cab, press the
soft key to enable Fold.
Note: If the monitor has not been installed, refer to the air
drill cart operator’s manual for instructions.
10. Engage the tractor lever for the Fold/Unfold circuit,
normally Retract, and slowly fold drill. When folded,
set tractor circuit lever to neutral.
11. If folding for the first time without the marker stop
fittings, watch carefully for clearances, and kinking or
pinching of hoses and cables.
12. Insert wing fold lock-up pins to secure folded wings.
Insert them in the highest available hole pair under
the tool bar.
Do not remove transport locks from a folded drill.
13. On seed monitor terminal, set Fold/Unfold to Off with
soft key.
Figure 34
Wing Lock Lugs
with Marker Stop Bolt
16217
2
1
3
2
1
2
3
Figure 35
Wing Lock, no Markers
16168
1
3
2
Figure 36
Wing Lock, with Markers
16217
3
2
1