Great Plains NTA2007HD Assembly Instructions - Manual (Page 13)

Great Plains Mfg., Inc. Front Parts Installation Instructions 13
2013-10-10 Front Parts 113-850M
Install Marker Disk and Guard
Install Third Stage Arm
Start with the left marker.
Refer to Figure 17
83. If pre-installed, loosen the jam nuts
and set
screws in the second stage arm .
If not pre-installed, select two sets new:
FNS-54JPC 1/2"- 13 NC Jam Nut
FNS-8A41BPC 1/2 x1-1/2"SQ HD SET YZ
Place a jam nut on a set screw . Screw this
assembly a few turns into the threaded holes on the
outer end of the arm
.
84. Select one new:
SFM-8665 Third Stage Arm SFM
Orient the disk mounting lug so that it is angled in
(toward implement center with markers folded).
Insert the third stage arm
fully into the second
stage arm .
85. Tighten the set screws to
1 ⁄
2
turn beyond finger
tight. (The initial marker extension is set at step 96.)
86. Repeat step 83 through step 85 for the right side.
The lug is angled in on the right side as well.
Install Bearing Assembly and Guard
Start with the left marker.
Refer to Figure 18
87. Select one each new:
SA-9041 Disc Assy Complete w/o DISC/GAUGE
SFM-8223 Disc Guard
and two sets new:
FNS-241C5PC 1/2x1-3/4"" Carriage Bolt 5 YZ
FNS-74RP 1/2" Flat Washer
FNS-94SLN 1/2" Stover Nut UNC YZ
Loosely mount the bearing assembly under the
arm lug , and the guard on top of the lug, bent
tube facing to implement rear (with arm folded).
Figure 18 shows the carriage bolt in the inside
small slotted hole for a left arm installation. This
provides maximum angles for throwing dirt inward in
operation. This is a user preference issue.
88. Repeat step 87 and step 87 for the right side. Use
the alternate small slotted hole.
Null4:
Figure 17
Install Third Stage Arm
31350
45
1
37 62
63
37
45 62
37
45
37 45
62
63
1
63
62
Null4:
Figure 18
Install Bearing Assembly
31351
34
2
52
54
53
63
43
47
39
39
53
54
34
43
47
53
63 54
34
2