Great Plains NTA2007HD Assembly Instructions - Manual (Page 8)

8 2013- Single Fold Marker Front Parts Great Plains Mfg., Inc.
113-850M Front Parts 2013-10-10
Install Cylinder Fittings
Refer to Figure 10
If elbows are pre-installed on the cylinders
, skip to
step 38.
37. Select four new:
HYD-2787 #6ORBx9/16"JICM 90 6801-0606
Loosely install the MORB ends of the elbows at the
cylinder ports.
38. If the elbows were pre-installed, loosen the jam
nuts.
39. Adjust the orientation of the elbows so that the
MJIC inlets face up, and toward each other at
roughly a 45
° angle. Tighten the jam nuts to ORB
torque spec.
Prepare Supply Hoses
Refer to Figure 11
40. Select two new:
HP-9JF100.375
3/8" HOSE X 100" 9/16 JICF ENDS
If the MORB-MJIC adaptors are already
installed on one end of each hose, skip to step 42.
41. Select two new:
HYD-6400680
ADAPTER 9/16 (#6) JICM - 3/4" (#8) ORB
Install one adaptor on each hose .
42. Select two existing:
811-070C CP 3/4FORB QD
Install one coupler on each adaptor .
43. If orange cable ties are available, secure one tie to
each hose end near the FJIC fitting. It is not neces-
sary to separately identify one hose from the other.
Prepare Cylinder Hoses
44. Select two (of four):
HP-9JF154
3/8" HOSE X 154" 9/16 JICF ENDS
If orange ties are available, secure one tie to each
hose end near the FJIC fitting. If orange ties are not
available, use tape, tags or indelible marking pen to
identify hose ends or connectors as “R”. These are
the rod-end hoses.
Null4:
Null4:
Figure 10
Cylinder Elbows
31344
49
48
49
48
49
49
49
Null4:
Figure 11
Marker Supply/Return Hoses
31336
72
12
75
72
75
75
75 72
12
12 75
73