Great Plains NTA2007HD Assembly Instructions - Manual (Page 2)

2 2013- Single Fold Marker Front Parts Great Plains Mfg., Inc.
113-850M Front Parts 2013-10-10
Before You Start
Compatibility
Refer to Figure 2
1.
Check the model number of the air drill against the
list at the top of page 1 to ensure it is a compatible
model. For example, this kit is not compatible with
the NTA2000 integrated air drill (which uses a differ-
ent marker kit).
Sequence
The mechanical installation may be performed on a dis-
connected implement, but testing of the system requires
the complete air drill.
If installing the markers as part of pre-delivery or export
final assembly, defer marker installation until after com-
pleting all items covered by manual 166-283Q.
Inventory
2. Make sure all parts are present.
Note: Delivered parts may be identified by Haukaas or
Great Plains part numbers. The Parts Lists begin-
ning on page 18 show both numbers.
Note: Some parts are provided in left- and right-hand
versions with different part numbers. These are
not interchangeable and must be installed on the
implement side specified.
Comprehension
3. Review these instructions. Make sure the installers
understand where each part or assembly is
installed, and what tools are required for the task.
Null4:
Null4:
Null4:
Null4:
Pinch / Crush Hazards:
Remove strapping only as instructed. The marker arms are
largely pre-assembled, and held closed by strapping. Prema-
ture removal creates pinch hazards and makes the assemblies
more hazardous to move and position.
Figure 2
NT607/2007HD Serial Number Plate
31174
Null4:
Figure 3
Markers on Pallet
31361