Great Plains 2420P Operator Manual - Manual (Page 37)

2012-04-17 118-769M
35 Adjustments
Refer to Figure 42
4. Pull seed meter wheel out about 1/4 inch, or
past the wheel drive pin, and spin backward to
clean out seeds from top pockets.
5. Remove seed meter wheel.
NOTE: With the seed meter wheel removed,
you may want to check the meter for internal
damage or trash.
Refer to Figure 43
6. Place new wheel on meter wheel shaft and
push meter slide retaining clip forward while
pushing in seed meter wheel.
Refer to Figure 44
7. Be sure slots in the center of seed meter
wheel are aligned with the wheel drive pin on
the meter shaft.
Figure 42
Remove seed meter wheel
18295
Spin wheel
backward before
removing
Wheel
drive pin
Retaining
clip
Figure 43
Place new seed meter wheel on wheel shaft
18296
Wheel
drive pin
Figure 44
Position seed meter wheel
18299