Great Plains DICKEY-john AI100 10-inch Virtual Terminal - Manual (Page 38)

OPERATOR’S MANUAL
10" Virtual Terminal
11001-1440-200701
36 / TASK CONTROLLER
MAIN OPERATE SCREEN
The Task Controller main operate screen identifies:
• GPS signal strength
• Data card status
• Task status (Initial, Running, Suspended, None Selected)
• Displays the task name, customer name, farm name, etc.
To access the Task Controller main screen:
1. Insert a data card into the Virtual Terminal (VT).
2. Press the Task Controller button at the VT Setup screen.
Figure 28
Task Controller Main Screen
DATA CARD
A data card is used to transfer information from the PC to the VT. An
hourglass will display when a taskdata.xml file is found on the SD card. If no
data card or a faulty data card is installed in the card slot, a message will
indicate data card issues.
Ensure the data card is formatted before inserting into the VT. Reference
the Formatting an SD Card section in this manual for formatting instructions.
GPS Signal
Strength Data Card
Status Task
Status
Select Operator
Task Controller button