Great Plains DICKEY-john AI100 10-inch Virtual Terminal - Manual (Page 57)

OPERATOR’S MANUAL
10" Virtual Terminal
11001-1440-200701
TASK CONTROLLER / 55
MAP CONTROLS
To navigate within the map, the appropriate navigation button must be
pressed first before pressing the desired field position on the map.
Zoom In and Out
Press the Zoom button first and then press on the desired area of the map
that will center in the map display and zoom twice the original size. Press a
second time to zoom in 4 times the original map size. Zoom Out works the
same as zoom in. There is no limit to the number of time zoom out can be
used. The map is centered on the screen wherever the map is touched and
the map size is reduced by half each time it is zoomed out.
Reset Map
Press the Reset Map button to return to the original (default) map.
Pan Map
Press the Pan Map button first and then press on the desired area of the
map to display a specific part of the field (north, south, east, west) in the
center of the map. There is no limit to the number of times Pan can be used.
Press the Reset map to return to the original position and size in the map
display.
Reset Reference (PC generated task only)
If the coordinates of a known location have drifted, the Reset Reference
button allows entry of new coordinates to re-establish correct field position
and will apply to all points in the field.
1. Press the Reset Reference button.
2. Arrows located to the right of the map will allow adjustment in
increments of 3.28 ft. in all directions when pressed.
3. Press the Checkmark to accept the new position or ‘X’ to cancel
entered data.
USING MAPS WITH NO BOUNDARIES
On a task that has no field boundary and displays a green map, the Reset
Reference button is not available.
Map controls for tasks with no field boundaries are used to move or adjust
the size of the display to keep the cursor and white machine trail on the
screen.
IMPORTANT: It is important to ALWAYS press the SD Card Eject
button before removing the SD card. Removing the SD
card without ejecting can potentially lose logged data.
NEXT CHANNEL TOTALS
After performing a task, a task summary that includes total material and
area accumulation for all active channels can be viewed on the Task
Controller Main screen at screen bottom.
Press the View Next button to cycle through total accumulations by control
channels.
View Next button
Zoom In and Out
Reset Map
Pan Map
Reset Reference