Great Plains DICKEY-john AI100 10-inch Virtual Terminal - Manual (Page 49)

OPERATOR’S MANUAL
10" Virtual Terminal
11001-1440-200701
TASK CONTROLLER / 47
VT GENERATED TASK
To run a VT-generated, single-rate task, the product and product type is
identified through Task Controller.
When there is more than one channel type configured on the IntelliAg
(planter control, granular seeding, liquid flow, or granular fertilizer), the
product being applied during a task must be defined.
IMPORTANT: If a product is created in the Task Controller that is not
assigned to a control channel at the IntelliAg Control
Channel Configuration screen, the channel selection
boxes at the Task Controller Select Bins screen will not
be selectable (
Figure 44 ).
To assign a product:
1. At the Task Controller Main screen, press the Assign Product button
to view the Add Product to Task screen. If there is only one channel
type selected, the Assign Product button will not appear on the Task
Controller Main screen.
2. Press the Select Product box to cycle through the existing product list.
To add a new product, press the Add New button.
3. Select a product and press the Checkmark to add a product to the
task. Pressing the Cancel button ‘X’ will not add any new products to
the task.
4. When the desired product appears in the Product selection box, the
Next button will display on the right. Press Next to continue.
Figure 40
Add Product to Task Screen
NOTE: Select Count for population/
planter control.
5. Select an Application Type of how material will be applied - liquid, dry,
or count.
seed
corn
corn
Select
Product
Add
New
Next button
Assign Product button