Great Plains ADI445 Operator Manual - Manual (Page 34)

32
Section 2 Operating Instructions
Model 2250 Air Drill Implement 160-192M 5/11/05
Great Plains Mfg., Inc.
•
Be certain that all tires are properly inflated as listed in
the Tire Inflation Chart in the “Appendix” section on
page 44.
•
Comply with all Federal, State, and local laws when
transporting on public roads.
•
Remember that the air drill cart bins and the wings of the
folded implement can obstruct your view. Be prepared
for sudden maneuvers from following vehicles.
NOTE: Never remove cylinder lock channels from a
folded implement.
Parking
The following steps should be performed when parking the
drill. Refer to Storage under the “Maintenance and Lu-
brication” section on page 39 for information on long term
storage preparation.
1. Raise and lock implement in storage position.
2. Place implement on a firm level area.
3. Securely block the drill tires to prevent rolling.
4. Unhook electrical lines and install plugs as provided.
5. Release pressure on the hydraulic system, then dis-
connect hydraulic lines. Be sure the ends do not rest
on the ground.