Assembly, Position for assembly, Assemble tongue to mainframe – Great Plains 3S-3000HDF Predelivery Manual User Manual
Page 10
8 3S-3000HD
195-068Q
12/09/2009
Assembly
Position for Assembly
1.
Unload mainframe (Legal Load) or drill (Wide Load)
from truck and place it in a location that allows for:
• tow away depth:
28 feet (8.5m) plus
length of tractor plus
turning room
• wing unfolding:
16 feet (4.9m) either side of centerline, or
32 feet (9.8m) total span), and
• if markers were ordered:
32 feet (9.8m) either side of centerline, or
64 ft (19.5m) total span.
If the drill was shipped as a Wide Load, skip to “Install
Wing Walkboards and Steps” on page 15.
Assemble Tongue to Mainframe
When space is available on the trailer, the tongue is fac-
tory-assembled, in which case skip to “Install Center
Box on Frame” on page 10.
2.
Block the mainframe assembly
up in the raised
position with the transport cylinders extended and
the cylinder lock channels
over the cylinder rods.
3.
With the aid of a fork-lift, hoist, or loader, position
the tongue assembly
back under the mainframe
assembly
and bolt it into place with the twelve
1x2
3
⁄
4
in bolts
, 1in flat washers
, 1in lock wash-
ers
and 1in nuts
.
Lightly tighten all 1in bolts before torquing any of
them.
4.
Once the tongue is assembled, remove the cylinder
lock channels
, completely lower the mainframe
assembly and secure it in this position.
5.
Route the two long
3
⁄
8
in hydraulic hoses
from the
back of the tongue tube along the right side of the
main frame and connect them to the
9
⁄
16
in bulkhead
tees
on the front of the main frame.
6.
Route the two long
1
/
4
in hoses
coming out of the
back of the tongue to the
9
⁄
16
in tees
on the rod
and base ends of the right fold cylinder.
The fold circuit hoses
run the full length of the
tongue.
7.
Secure the hoses
and
with a hose clamp
bracket
and
5
⁄
16
x2
1
/
4
in bolts
and
5
⁄
16
in lock
washers
.
Use rubber hydraulic hose guards
on the
1
/
4
in
hydraulic hoses.
8.
Route the long
1
/
4
in hose
coming from the base
end of box lift cylinder at the center of the tongue to
the
9
⁄
16
in base end tee
at the right transport lift
cylinder on the transport axle.
Route the long
1
/
4
in hose
coming from the rod
end of box lift cylinder at the center of the tongue to
the
9
⁄
16
in rod end tee
at the right transport lift cyl-
inder on the transport axle.
1
2
3
1
4
5
6
7
2
8
9
10
11
10
8
10
12
13
14
15
16
17
18
19