Great Plains 3S-3000HDF Predelivery Manual - Manual (Page 35)

Setup 33
12/09/2009 195-068Q
Align Transfer Drive Shaft
Refer to Figure 37 and Figure 38
After wing boxes are properly aligned, the transfer drive
shaft must be aligned so the pair of break-away jaws
are fully engaged and are concentric. The
7 ⁄
8
in hex drive
shafts holding the clutch jaws should not contact each
other
when wing boxes are properly aligned and back
against their stops.
1. Place a 4x4in (10x10cm) or similar sized block
ahead of the wing gauge wheels and pull forward or
push wing box frames back until the tool bar is firmly
against tool bar stop bolts on the center box frame.
2. To align the clutch jaws vertically, loosen the two
5 ⁄
8
inch bolts securing the bearing flangettes .
Slide the flangettes in the desired direction. Tighten
bolts.
Figure 37
Transfer Drive Jaws
18955
1
2
3
4
Figure 38
Transfer Drive Shaft Front-Back Adjustment
15620
3
4
1
2
3 4