Great Plains 3S-3000HDF Predelivery Manual - Manual (Page 21)

Assembly 19
12/09/2009 195-068Q
5. Skip to “Other Assembly Items” on page 19.
Wing Swing-Down Ladder Decals
Refer to Figure 16
Starting on the left wing walkboard:
1. Place the 838-102C Danger Falling Hazard decal
forward of and near the top of the ladder, where it is
visible to climbers.
2. Place one 838-265C Amber decal on the outside of
the ladder mount, between the ladder side plates
(so it won’t be damaged by ladder operation).
3. Place one 838-265C Amber decal on the rear and
corner
of the ladder mount. This decal is slightly
longer than that side of the mount. Wrap the excess
around the corner.
4. Repeat for right wing section walkboard ladder.
Other Assembly Items
There are a few additional standard components, and
several possible optional items, that are not factory
installed. Some of these, which follow in this chapter,
need to be installed prior to first hydraulic hookup. Oth-
ers are installed after hookup, bleeding and leveling.
See “Install Final Accessories” on page 36.
Install Press Wheels
Refer to Figure 17
1.
Remove 1 ⁄
2
x3 3 ⁄
4
inch flange bolt and flange lock
nut from each opener body.
2. Leave pivot bushing components in place and
bolt press wheel arm to opener with 1 ⁄
2
x3 3 ⁄
4
inch
flange bolt and lock nut . Repeat for all open-
ers.
3. Remove 5 ⁄
8
inch bolt from each press wheel arm
and use bolts to assemble press wheels to
press wheel arms.
Figure 16
Swing-Down Ladder Decals
27016
3
1
2
1
2
3
Figure 17
Press Wheel Assembly
24432
1
2
3
4
5
6
1
2
3
4
1 2
5
4 6