Great Plains 3S-3000HDF Predelivery Manual - Manual (Page 8)

6 3S-3000HD
195-068Q 12/09/2009
Preparation
Step-by-step instructions for assembling the implement
begin in the next section of the manual. Before com-
mencing work, review the Tools Required and Pre-
Assembly Checklist to make sure you have all neces-
sary parts and equipment.
The implement is shipped via flat bed truck. It is the
dealer’s responsibility to unload the new machine.
Unload all equipment before beginning assembly.
Scope The Work
Depending on the shipping route and destination, the
3S-3000HD drill may require only light component
installation (Wide Load), or it may require assembly of
major components (Standard Load).
Overview of Work
All fasteners and misc. components are located in their
assembly location, or in bags/cartons inside a drill seed
box.
Assembly
1. Unload truck.
2. Assemble major sections (Legal Load only).
3. Install walkboards, steps/ladders and decals.
4. Install other standard and optional components that
were not factory-installed, but need to be present
prior to first hydraulic operations, such as press
wheels.
Setup
5. Hitch to suitable tractor.
6. Connect hydraulics.
7. Bleed hydraulics.
8. Level drill.
9. Install any other components or options not factory-
installed.
Wide Load Assembly
The drill is shipped substantially assembled, less wing
walkboards, press wheel arms, press wheels, walk-
board reflector decals, accessories and some options.
The following items are installed after delivery, in this
approximate order:
• Wing walkboards (2)
• Walkboard fixed step or swing-down ladder
• Wing walkboard decals
• Additional options and accessories not factory-
installed, such as acremeter, press wheels, markers,
hydraulic kits, shaft monitors and scrapers.
Standard “Legal” Load Assembly
The drill is shipped substantially disassembled, to keep
the trailer under 8.5ft wide.
The following items are assembled/installed after deliv-
ery, in this approximate order:
• Tongue to mainframe assembly
• Center box to Main frame assembly
• Left hand wing box
• Right hand wing box
• Transfer drive shaft
• Additional options and accessories not factory-
installed, such as acremeter, press wheels, markers,
hydraulic kits, shaft monitors and scrapers.
Do not attempt any assembly work while the implement is on
the truck.