Great Plains 3S-3000HDF Predelivery Manual - Manual (Page 36)

34 3S-3000HD
195-068Q 12/09/2009
Refer to Figure 39 and Figure 40
3.
To align the clutch jaws vertically, loosen the two
5 ⁄
16
inch bolts at the bottom of the breakaway
clutch bracket , and adjust the bracket as needed.
4. To adjust clutch jaws for full jaw contact, loosen the
two
5 ⁄
16
inch carriage bolts and slide breakaway
clutch bracket until jaws on the fixed half of clutch
make full contact with jaws on spring loaded half of
clutch without compressing clutch spring.
Note: The two 7 ⁄
8
inch hex shafts should have 1 ⁄
8
inch
(3.2mm) gap between them when the clutch
jaws have full contact.
Figure 39
Transfer Drive Shaft Gap
18955
2
1 7 7
Figure 40
Transfer Drive Shaft Vertical and Left-Right Adjustment
15621
6
5
7
7
8
9
1
5
6
8
9
7
2