Great Plains NTA3007HD Predelivery Manual - Manual (Page 17)

Unloading the Racks 13
03/29/2010 166-207Q
Refer to Figure 19
8.
Place an overhead strap attached to the forklift
through the top hole in one wing weldment.
9. Remove the U-bolt holding the wing to the rack.
Refer to Figure 20
10. Hoist the wing weldment off the rack.
Refer to Figure 21
11. Set the wing weldment on the floor or location where
the drill will be assembled.
Figure 19
Remove U-bolt Holding Wing
Weldment to Rack
7644
Figure 20
Hoist Wing Weldment off Rack
7643
Figure 21
Wing Weldment
7647