Great Plains FH6800HD Predelivery Manual - Manual (Page 33)

Great Plains Manufacturing, Inc. Assembly 29
01/14/2014 564-070Q
Install Lights
The lights will be installed on brackets from factory. The
30’ light harness
will be run through tube on center
frame with hydraulic hoses to front of center frame. The
light harness connectors will be labeled on where they
hook to.
Refer to Figure 36
98. Select one:
833-693C LIGHT HARNESS, 30’ LEAD-LED
833-694C LIGHT HARNESS, ENHANCE MOD-
ULE-LED
833-695C LIGHT HARNESS, 12’ WISHBONE-
LED
and two:
833-696C LIGHT, RED LAMP-LED
833-697C LIGHT, AMBER LAMP-LED
99. Plug one end of light harness into enhance mod-
ule .
100.Plug big end of light harness into enhance mod-
ule and other ends into appropriate red and
amber light harness,
101.Fasten light harness up to frame with plastic ties or
hose clips, be sure and leave enough slack to where
the harness does not get pinched when folding.
Adjust Wing Fold Height
See Wing Fold Height Adjustment in “Operator’s Manual”
for details.
Pre-Delivery Closeout
102.Remove all part tags. Wipe off all grease pencil part
numbers.
103.Place all manuals, and any unused height adjust-
ment shims, in the Manual-Pak
®
.
104.Check that all working parts are moving freely, bolts
are tight, and cotter pins are spread.
105.Check that all grease fittings are in place and lubri-
cated. See Lubrication and Scheduled in “Operator’s
Manual”.
106.Check that all safety decals and reflectors are cor-
rectly located and legible. Replace if damaged. See
Safety Decals in “Operator’s Manual”.
107.Inflate tires to pressure recommended and tighten
wheel bolts as specified. See “Tire Inflation & War-
ranty” on page 32.
Figure 36
Light Details
42323
94
97
97
95
96
96
95
93 93
93
94
95
96
97
95
94
95
94 96
97