Fertilizer pump rate – Great Plains 1625AHL Material Rate User Manual
Page 100
96
1625AHD/AHL
Great Plains Manufacturing, Inc.
411-020B
2014-03-17
Fertilizer Pump Rate
Refer to Figure 25 and Figure 26
Coarse rate is set by a single “driving” sprocket
on the
ground drive assembly. Fine rate is set on a dial (setting
hub)
at the pump
, using a tool supplied with the
pump.
Rate settings may be established in any of three ways:
• the table on the next page,
• the slide chart provided with the pump, or;
• a calculator on the CDS-John Blue
®
internet web site
)
1.
Check plumbing setup. See “Setting Relief Valve”
and “Strainer” in the Operator Manual.
2.
Determine Driving sprocket (15T or 47T) required
from table, slide chart or web calculator. If this
sprocket is already installed on driven shaft, skip to
step 7. Otherwise, to change sprocket, continue with
step 3.
3.
Remove knob
and guard
. Loosen idler
, and
remove chain
from lower jackshaft
.
4.
Select the new sprocket from the storage shaft
.
Remove the pins, and exchange sprockets. Store the
previous sprocket on the storage shaft.
5.
Remount the chain
. Re-engage idler
, tightening
so that the longest span of the chain has
1
⁄
4
inch (6 mm) of slack.
6.
Remount guard
and secure with knob
.
Refer to Figure 26
7.
Use the box-wrench end of the JohnBlue 115681-01
tool, and loosen the setting pointer nut
.
8.
Use the other end of the tool to rotate the dial
to
the setting determined by table, slide chart or web.
9.
Re-tighten pointer nut.
Material Loss / Pump Damage Risks:
Disconnect chain or remove sprocket when not intending to
apply material. Contact wheel and chain system operate
whenever the planter is lowered and in motion. If planting
without fertilizing, the pump must not be allowed to run dry.
Figure 25
CDS-John Blue
®
Pump
28416
2
1
3
4
5
6
7
8
1
2
3
4
5
6
7
1
8
7
6
5
4
8
Figure 26
Pump Dial
26155
2
8
2
Figure 27
CDS-John Blue
®
Slide Chart
26156