Configure pm400 monitor, Configure mvt monitor, Configure pm400 monitor configure mvt monitor – Great Plains 1625AHL Material Rate User Manual
Page 27
Great Plains Manufacturing, Inc.
Singulated Planting
23
2014-03-17
411-020B
Configure PM400 Monitor
These instructions are for the DICKEY-john
®
PM400
monitor, singulated seeds and the monitor in Population
mode.
Refer to Figure 7 (depicting a 1625AHD-32TR30,
U.S. customary units, rows in Population mode)
1.
Press the PLANTER SETUP
key. Press the
Right Arrow
key to select Configuration 1
a
.
This moves the Planter Configuration Indicator
under the “1” in the Configuration block
.
2.
Use the Down Arrow key (
or
) to move the
input focus to Row I/O at the bottom of the screen.
Press the ENTER
to begin altering row I/O. This
auto-selects row 1. Rows default to population
mode
(your setup may vary).
3.
As each row icon is selected, press the
Up or Down Arrow key (
or
)
to change the icon to population mode
.
4.
Press the Right Arrow key (
) to move to the next
row.
Repeat step 3 and step 4 until all rows are Blockage.
Changes are saved as made.
5.
Press the Operate button
to begin planting.
Configure MVT Monitor
These instructions are for the DICKEY-john
®
MVT (Mini
Virtual Terminal) monitor, singulated seeds and the
monitor in Population mode.
If the planter has recently been used to plant small seeds
such as canola, verify that the SEED ROW SETUP is set
to pattern “ALL POPULATION”, or set individual rows
from blockage mode
to population mode
.
a. The convention in this manual, for the PM400 monitor, is Configuration 1:Singulated/Population, 2:Singulated/Blockage,
3:Volumetric/Blockage.
Figure 7
PM400 Population Setup
36108
Figure 8
MVT Population Setup
36224