Great Plains NTA2000D Operator Manual - Manual (Page 24)

22 NTA 2000D 148-632M 9/13/2006
Great Plains Mfg., Inc.
Unfolding the Drill
Unfold the drill on level ground. Be aware of clearance
required to fold implement. Refer to “Specifications and
Capacities,” page 47.
!
WARNING!
Pinch Point and Crushing Hazard. To prevent serious injury or
death. Be certain the drill is hitched securely to your tractor
drawbar and the hitch safety chain is securely attached to the
tractor before raising or unfolding the drill.
• Unfold the wings with the drill raised.
• Fold only if hydraulics are bled free of air and fully charged
with hydraulic oil.
• Keep away and keep others away when folding or unfolding
drill
Opener Extensions.
Refer to Figure 14
1. Remove transport lock pins from opener wings and
place in storage holes indicated by arrow.
Refer to Figure 15
2. Make sure the lock levers are in the unlock position.
The levers should be in a position which is pointing
away from the frame.
3. Unfold the drill on level ground with the tractor in neu-
tral.
!
DANGER!
Electrocution hazard. To prevent serious injury or death from
electric shock, keep clear of overhead power lines when trans-
porting, folding, unfolding or operating all air-drill compo-
nents. Machine is not grounded. Electrocution can occur
without direct contact.
Refer to Figure 16
4. When opener wings are in their lowered position lock
in place by engaging the lock levers. The levers should
be pushed towards the frame to lock.
Figure 14
Lock Pin
Figure 15
Lock Lever
Figure 16
Lock Lever
19736
19740
19741