Great Plains NTA2000D Operator Manual - Manual (Page 58)

Multi-function Drill Control
38r
Summary of Program Modes 1 – 3
Most settings do not need to be accessed during normal operation, unless perhaps
the instrument is transferred to another tractor/implement. Default values shown in
[brackets].
Mode 1 Mode 2 Mode 3
Mode Entry From normal display
mode, select channel
and hold +1 button
continuously
Press and hold
button while plugging
instrument in
Press and hold for
ten seconds the
STOP button while
plugging instrument
in
Channel
Selection
As Above Press button Press button
Channel 1 Speed Sensor Factor
[2.000]
see page d
Forward Speed Alarm
On (1) / Off (0)
[1]
No function
Channel 2 Implement Width
[240.0 in]
see page f
Metric/Imperial
Selection
[Metric]
see page d
Display Grand Total
Area
(non-resettable)
Channel 3 Tramline Sequence
/Target Bout
[SY04]
see page n
Tramline Option
On (1) / Off (0)
[1]
Tramline Option
On (1) / Off (0)
[1]
Channel 4 Low Fan Speed
Alarm
[2700rpm]
see page o
High Fan Speed
Alarm
[4500rpm]
see page o
Fan speed Sensor –
pulses per rev. Set
0 to inhibit fan
speed channel
[1.000]
Channel 5 Distribution Shaft –
Alarm Speed
[0]
see page p
Distribution Shaft -
Alarm Delay
[40 sec]
see page q
Dist. Shaft Sensor –
pulses per rev. Set
0 to inhibit Shaft
Speed channel
[3.000]
Channel 6 Hopper Level Alarm
On (1) / Off (0)
[1]
see page q
No function No function