Bio-Rad Components for Older Model Spot Cutter - Manual (Page 23)

7.4 Operation Menu
Selecting the Operation menu displays the following drop down menu.
Project Number
Select this menu to change or add a new Project number and or Gel/PVDF number.
New Project
Select this menu to change or add a new Project number and or Gel/PVDF number.
Using this menu, any currently selected spots not yet cut will be lost.
Calibration
This function is used to calibrate the x, y movements of the cutting head Alternatively you may
select the Manual calibration shortcut buttons located below the menu bar (see Appendix D).
Upon selecting the calibration menu the Serial Number box will appear.
You must click on the Enter Serial Number text field and type in the serial Number.
(The serial number was provided when the system was delivered).
Light On/Light Off
Selecting this menu will either turn system lights on or off, depending on their current
state.
(a) Lights on can also be achieved by pressing the Light On shortcut button located
below the menu bar. (see Appendix D)
(b) Light off can also be achieved by pressing Light Off shortcut button located
below the menu bar. (see Appendix D)
(c) The lights may be turned on temporarily at any time by pushing and holding in
the lights on push button located at the front of the system. See Appendix A.
Move to Home
Select this menu or press the Move to Home Position shortcut button located below the
menu bar (see Appendix D) to move system cutting head to the home position. This is the
location at the top left-hand corner of the working surface. This position may be used for
changing cutting tips.
19