Bio-Rad Model 550, Ultramark, and Benchmark Microplate Reader Accessories - Manual (Page 23)

4. The cursor begins under the first digit of the Upper limit. Use either ARROW to
change the first digit.
5. When the first digit is set, press NEXT to move the cursor to the first decimal posi-
tion. Set the first decimal digit with the ARROW. Continue moving to the right with
NEXT until all four digits of the Upper limit are set.
6. When the last digit of the Upper limit is set, press SELECT to move the cur-
sor to the first digit of the Lower limit.
7. Set the Lower limit as the Upper limit with ARROW and NEXT.
8. When the Upper and Lower limits are set, press ENTER. The display will return to
the previous screen.
Set Cutoff Mode
1. Press MODE until the display reads
2. Press either ARROW until the display reads
3. Press ENTER and the display will change to
4. There are two types of Cutoff reports: Constant and Formula (described in Section 4.1).
a. Use either ARROW to move the cursor under the check box for C/F.
b. Press SELECT to darken the check box.
c. Press ENTER. The display changes to
20
>SET LIMITS
MODE
>PRINT REPORT
MODE
■ ■ C/F ■ ■ Set Const
■ ■ Set Formula
Select C/F
■ ■ Const / ■ ■ Formula
>SET CUTOFF
MODE