Cooper Instruments & Systems DFI Infinity CS Economy Digital Indicator - Manual (Page 11)

DFI INFINITY CS (V- M3598/N/0906) 8 CF 70
Figure 3-2 Main Board Jumper Positions
Figure 3-3 Upper Isolated Analog Output Option Board Installation
S2 jumpers are used for testing purposes. Do not use as reading errors may result.
S3 jumpers are used for the following (refer to Figure 3-2):
• To enable or disable the front panel push-buttons
• To allow for an extremely low resistance load button for analog output
• To disable the MENU button
• To perform factory calibration procedure
Test pins TP1 – TP11 are for testing purposes. Do not use as reading errors may result.
S4-A factory default jumper is removed.