Cooper Instruments & Systems DFI Infinity CS Economy Digital Indicator - Manual (Page 6)

DFI INFINITY CS (V- M3598/N/0906) 3 CF 70
• Use electrical wires with adequate size to handle mechanical strain and power requirements. Install
without exposing bare wire outside the connector to minimize electrical shock hazards.
EMC Considerations
• Whenever EMC is an issue, always use shielded cables.
• Never run signal and power wires in the same conduit.
• Use signal wire connections with twisted-pair cables.
• Install Ferrite Bead (s) on signal wires close to the instrument if EMC problems persist.
Failure to follow all instructions and warnings may result in injury!
2.0 ABOUT THE METER
2.1 Description
The Digital Programmable Strain meter is a value packed indicator/controller. Four full digits and broad scaling
capability allow for a display in virtually all engineering units. A wide variety of DC current and voltage input ranges
cover typical strain applications. Standard features include sensor excitation and front panel or remote tare. Your
meter may be a basic indicator or it may include analog output or dual relay output. Analog or dual relay output
must be ordered at time of purchase. Analog output is fully scalable and may be configured as a proportional
controller, or to follow your display. Dual 5 amp, form C relays control critical processes. A mechanical lockout has
been included to guard against unauthorized changes.
2.2 Features
The following is a list of standard features:
• 4-digit, three color Programmable, Big LED display or
4-digit, Standard LED display
• NEMA 4 Front Bezel
• ±0.03 % accuracy
• 8 DC input ranges: 0-100 mV, ±50 mV, 0-5 V, 1-5 V, 0-10 V, ±5 V, 0-20 mA, and 4-20 mA
• 5,10,12, or 24 Vdc sensor excitation
• Peak detection
• Front panel and remote tare function
• Nonvolatile memory-no battery backup
• 115 or 230 Vac 50/60 Hz power supply or
10 – 32 Vdc or 26-56 Vdc
The following is a list of optional features:
• Dual 5 amp, form C relay output
• Scalable analog output
• Proportional control
• Easy setup for proportional control
2.3 Available Accessories
Table 2-1 Accessories and Add-Ons
Add-On Options
FS Special
Calibration/Configuration
SPC4 NEMA-4 Splash proof Cover
SPC18 NEMA-4 Splash Proof Cover, NEW
Accessories
TP1A Trimplate panel adaptor - Adapts DIN1A/DIN2A cases to larger panel cutouts
RP18 19-in. Rack Panel for one (1) 1/8 DIN instrument
RP28 19-in. Rack Panel for two (2) 1/8 DIN instruments